If you purchase this report now and we update it in next 100 days, get it free!
The global central battery systems market is shaped by safety standards governing centralised emergency power supply, battery performance, automatic testing and the operation of connected emergency luminaires. Unlike self-contained emergency lighting, central battery systems use a shared battery bank to supply multiple connected luminaires and other essential safety equipment. EN 50171:2021 establishes the requirements for central power supply systems and distinguishes between two configurations. A Central Power Supply System (CPS) has no output power limitation, while a Low Power Supply System (LPS) is limited to 1,500 W for one hour or 500 W for three hours of emergency operation. The standard requires the power supply to serve only essential safety equipment, prohibits its use for general-purpose IT or industrial loads, requires the inverter to start the full load without mains power and specifies full battery recharge within 24 hours after complete discharge. The connected emergency luminaires are governed by EN IEC 60598-2-22:2022, which establishes safety requirements for emergency lighting equipment connected to central power sources. In France, EC 11 regulation requires each room and each clearance exceeding 15 metres to be supplied by two separate circuits routed independently, ensuring that the failure of one circuit does not eliminate evacuation lighting. Automatic testing is addressed by IEC 62034:2012. The standard covers functional and duration testing, including the monitoring of timing circuits, communication failures, component failures and software failures in automatic test systems for battery-powered emergency escape lighting operating at supply voltages not exceeding 1,000 V.
In North America, UL 924 applies to emergency lighting and power equipment installed in unclassified locations on branch circuits rated at 600 volts or less. Its scope includes central station battery banks, inverters, automatic battery charging equipment and control systems. NFPA 101, the Life Safety Code, requires emergency illumination for at least 90 minutes following normal power failure, with transfer to battery power within 10 seconds. New emergency power systems must meet the Type 10, Class 1.5, Level 1 classification. Testing requirements include an automatic 30-second functional test at least once every 30 days and an annual test demonstrating the required 90-minute duration. Computer-based self-testing and self-diagnostic systems can be used as alternatives to manual testing. Battery sustainability and chemistry regulations are becoming increasingly important to market access. EU Regulation 2023/1542 applies to industrial batteries and introduces carbon-footprint, supply-chain due-diligence and recycled-content requirements. LightingEurope has advocated classifying emergency lighting batteries as industrial rather than portable batteries, which would bring them under the relevant industrial battery obligations rather than portable battery removability requirements. From 18 August 2031, the regulation establishes recycled-content thresholds of 16% for cobalt, 85% for lead, 6% for lithium and 6% for nickel in applicable industrial batteries. Recycling efficiency targets from the end of 2025 include 75% for lead-acid batteries and 65% for lithium-based batteries.
What's Inside a Bonafide Research`s industry report?
A Bonafide Research industry report provides in-depth market analysis, trends, competitive insights, and strategic recommendations to help businesses make informed decisions.
Competition in the central battery systems market is shaped by system architecture, battery chemistry, regulatory compliance and the ability to automate testing and monitoring. Suppliers must address different building requirements while maintaining compliance with regional safety and battery regulations. System architecture is a key differentiator. CPS systems support unrestricted output power and are suitable for large facilities such as hospitals and high-rise buildings. LPS systems are limited to 1,500 W for one hour or 500 W for three hours, making them more suitable for smaller buildings and distributed emergency lighting installations. Battery chemistry also influences supplier positioning. Lead-acid batteries remain established due to their relatively low cost and mature recycling infrastructure. Lithium iron phosphate (LFP) is gaining attention because of its longer cycle life, lower maintenance requirements and remote monitoring capabilities. However, China's GB 17945-2024 restricts several cobalt-containing lithium-ion chemistries in fire emergency lighting and evacuation indication systems, while permitting LFP. The standard also restricts lead-acid batteries in self-contained luminaires and lithium-ion batteries in B-type central power supplies. Automatic testing and monitoring capabilities provide another competitive advantage. IEC 62034 and NFPA 101 testing obligations make automated functional and duration testing valuable for reducing recurring inspection labour. Systems with integrated monitoring software can provide information on battery condition, system failures and operational status. A 2026 study published in DYNA Journal Engineering comparing emergency lighting modernisation options in industrial environments found that individual-battery luminaires with automatic testing were the most cost-effective option in the analysed case. Centralised battery solutions, however, offered lower environmental impact and were more suitable for facilities with high-mounted luminaires where maintenance access is complex and expensive.
Market DynamicsDriver: Increasing demand for centralised emergency power in large facilities • Central battery systems are particularly relevant in large facilities where emergency loads exceed the LPS capacity limits or where accessing individual luminaires for battery replacement is difficult. EN 50171:2021 provides the CPS and LPS classification, while NFPA 101 establishes the required emergency lighting duration, transfer time and testing frequency. • Automatic testing systems compliant with IEC 62034 can reduce the labour involved in conducting recurring functional and duration tests. This is particularly beneficial in warehouses, industrial facilities and buildings with high-mounted luminaires, where manual inspection and maintenance require additional access equipment.
Challenge: Battery chemistry restrictions and regulatory differences • Battery chemistry requirements vary across major markets, creating challenges for manufacturers supplying internationally. China's GB 17945-2024, effective 1 May 2025, prohibits cobalt lithium, nickel-cobalt-manganese lithium and other cobalt-containing lithium-ion chemistries in fire emergency lighting and evacuation indication systems, while permitting lithium iron phosphate. It also prohibits lead-acid batteries in self-contained luminaires and lithium-ion batteries in B-type central power supplies. • The EU Battery Regulation 2023/1542 introduces additional recycled-content and supply-chain documentation requirements for applicable industrial batteries. Its thresholds from 18 August 2031 include 85% recycled lead and 6% recycled lithium. Manufacturers must therefore consider battery chemistry, material sourcing and regulatory documentation when developing products for different markets.
Make this report your own
Have queries/questions regarding a report
Take advantage of intelligence tailored to your business objective
Reecha Roy
Research Analyst
Trend: Integration of automatic testing, remote monitoring and lithium iron phosphate batteries • Central battery systems are evolving from conventional backup power installations into monitored building safety assets. IEC 62034 provides the framework for automatic functional and duration testing, while NFPA 101 establishes recurring testing obligations. Integrated monitoring can help facility operators identify battery deterioration, system faults and maintenance requirements. • Lithium iron phosphate batteries are gaining attention because of their longer cycle life, lower maintenance requirements and suitability for remote monitoring. The combination of automated testing and battery monitoring is increasing the importance of control systems, communication interfaces and monitoring software alongside the battery itself.
Segmentation AnalysisBy System Type • AC central battery systems convert the battery's DC output into AC power through an inverter, allowing the central plant to supply standard AC emergency luminaires. They are suitable for larger installations where the emergency load requires a centralised power source and can be designed around the CPS classification under EN 50171:2021. • DC central battery systems distribute DC power directly to luminaires designed for DC operation. Their use depends on the compatibility of connected luminaires and the acceptable voltage drop across distribution cables. Testing must also consider voltage at the furthest connected luminaire to ensure that distribution losses do not compromise the required lighting performance.
By Battery Chemistry • Lead-acid batteries remain widely used because of their relatively low cost, established performance and mature recycling infrastructure. The EU Battery Regulation's recycled-content threshold of 85% for lead from 2031 and its 75% lead-acid recycling-efficiency target from the end of 2025 are relevant to this segment. • Lithium-ion batteries, particularly lithium iron phosphate, are gaining adoption due to longer cycle life, lower maintenance requirements and remote monitoring capabilities. However, China's GB 17945-2024 restricts cobalt-containing lithium-ion chemistries in fire emergency lighting systems and permits LFP, making destination-market requirements important in battery selection. • Nickel-cadmium batteries retain a niche in high-temperature and high-reliability applications because of their tolerance to demanding operating conditions. However, the EU's 80% recycling-efficiency target for nickel-cadmium batteries by the end of 2025 and wider regulatory pressure on cadmium affect the segment's outlook. • Other chemistries, including sodium-based and flow batteries, remain at the research and pilot stage rather than representing established commercial options in central battery systems.
Don't pay for what you don't need. Save 30%
Customise your report by selecting specific countries or regions
By Capacity • Low-capacity systems generally operate within the LPS limits of 1,500 W for one hour or 500 W for three hours. They serve smaller commercial buildings, retail units and individual floors where a distributed emergency power architecture is appropriate. • Medium-capacity systems serve mid-rise commercial and institutional buildings where emergency loads exceed LPS limits but can be supported economically by a single CPS installation. • High-capacity systems are used in hospitals, high-rise buildings, transportation infrastructure and large industrial facilities. Their capacity requirements depend on the essential safety loads being supplied, including emergency lighting and other eligible fire safety equipment. EN 50171 requires central power supplies to be dedicated to essential safety equipment, so general-purpose building loads must be excluded from capacity calculations.
By Application • Emergency lighting is the primary application of central battery systems. These installations supply evacuation lighting and exit signage when normal power fails. NFPA 101's 90-minute emergency duration requirement and EN 50171's 24-hour recharge requirement influence battery capacity and charger specifications. • Fire safety systems, including eligible fire alarm and smoke control equipment, may also use central emergency power where the system is designed and approved for those essential safety loads. • Security and surveillance systems use backup power to support cameras and access-control equipment during power interruptions, subject to the applicable system design and safety requirements. • Critical infrastructure applications include data centres, telecommunications facilities and transportation control systems where reliable backup power is essential. Centralised systems can be suitable where the connected emergency load and maintenance requirements justify a shared battery installation.
By End-user • Commercial buildings, including offices, retail spaces and hospitality properties, use central battery systems to support emergency evacuation lighting. Selection between centralised and self-contained systems depends on building size, maintenance access and applicable safety requirements. • Industrial facilities use central battery systems where high-mounted luminaires and complex operating environments make individual battery maintenance expensive. Centralised installations can reduce the need for frequent access to individual lighting fixtures. • Healthcare facilities require reliable emergency power for evacuation lighting and essential safety operations. Hospitals may also have specific requirements for emergency lighting at locations containing Level 1 and Level 2 emergency power supply equipment under NFPA 110. • Transportation infrastructure uses central battery systems in facilities such as stations, terminals and transport control buildings, where emergency lighting and operational continuity are important. • Government and public facilities adopt central battery systems in large buildings and public infrastructure where emergency lighting reliability, maintenance accessibility and regulatory compliance are key procurement considerations.
Regional Analysis • Europe follows EN 50171:2021 for central power supply systems, including CPS and LPS classification, essential safety load requirements and the 24-hour battery recharge requirement. EN IEC 60598-2-22:2022 governs emergency luminaires, while IEC 62034:2012 addresses automatic testing systems. France's EC 11 regulation requires two separate circuits routed independently for each room and each clearance exceeding 15 metres. National adoptions include NF EN 50171 in France and DIN EN 50171 in Germany. EU Regulation 2023/1542 introduces carbon-footprint, supply-chain and recycled-content obligations for applicable industrial batteries. The regulation also establishes recycling-efficiency targets for lead-acid, lithium-based and nickel-cadmium batteries. • North America follows UL 924 for central station battery banks, inverters, charging equipment and emergency power controls. NFPA 101 establishes the 90-minute emergency lighting duration, 10-second transfer requirement, monthly 30-second functional test and annual 90-minute duration test. NFPA 110 also requires battery-powered emergency lighting at Level 1 and Level 2 emergency power supply equipment locations. • China's GB 17945-2024, effective 1 May 2025, replaced GB 17945-2010 and introduced battery chemistry restrictions for fire emergency lighting and evacuation indication systems. It prohibits cobalt lithium, nickel-cobalt-manganese lithium and other cobalt-containing lithium-ion chemistries while permitting lithium iron phosphate. Market access is also influenced by CCC certification under CNCA-C18-03:2024 and the applicable CCCF implementation rules. • India's central battery systems market follows the applicable Indian Standards and National Building Code framework. The Bureau of Indian Standards and National Building Code Part 4: Fire and Life Safety provide relevant requirements for building fire safety and emergency lighting installations. Central battery systems are used in hospitals, high-rise buildings and large projects, where protected battery banks in dedicated rooms supply emergency luminaires through fire-resisting cables. • Saudi Arabia requires SASO and IECEE certification for emergency lighting products. Emergency escape lights are exempt from SASO 2870 and 2902 energy-efficiency registration but remain subject to IECEE safety certification and SABER clearance. Saudi Building Code SBC 201 establishes operational, installation and maintenance requirements for emergency lighting systems in commercial and public buildings. • The UAE General Directorate of Civil Defense accepts testing to EN 60598-2-22 for emergency luminaires, EN 62034 for automatic test lighting systems and EN 50171 for central battery lighting systems. The UL Solutions Carugate laboratory is recognised to issue test reports against UAE requirements.
Considered in this report • Historic Year: 2020 • Base year: 2025 • Estimated year: 2026 • Forecast year: 2031
Aspects covered in this report • Global Central Battery Systems Market with its value and forecast along with its segments • Various drivers and challenges • On-going trends and developments • Top profiled companies • Strategic recommendation
By System Type • AC Central Battery Systems • DC Central Battery Systems
By Battery Chemistry • Lead-Acid • Lithium-Ion • Nickel-Cadmium • Other Chemistries
By Capacity • Low Capacity • Medium Capacity • High Capacity
By Application • Emergency Lighting • Fire Safety Systems • Security & Surveillance • Critical Infrastructure
By End-user • Commercial Buildings • Industrial Facilities • Healthcare Facilities • Transportation Infrastructure • Government & Public Facilities
Request Table of Contents
Central Battery Systems Market Research FAQs
Key driver: Increasing demand for centralised emergency power in large facilities. Key challenge: Battery chemistry restrictions and regulatory differences. Key trend: Integration of automatic testing, remote monitoring and lithium iron phosphate batteries.
The report uses 2020 as the historic year, 2025 as the base year, 2026 as the estimated year, with forecasts up to 2031.
The Global Central Battery Systems Market is analysed by system type (AC Central Battery Systems, DC Central Battery Systems); battery chemistry (Lead-Acid, Lithium-Ion, Nickel-Cadmium, Other Chemistries); capacity (Low Capacity, Medium Capacity, High Capacity); application (Emergency Lighting, Fire Safety Systems, Security & Surveillance, Critical Infrastructure); end-user (Commercial Buildings, Industrial Facilities, Healthcare Facilities, Transportation Infrastructure, Government & Public Facilities).
The report covers Global.
This report is open for pre-booking. Pre-book it to receive the full report as soon as it is released. You can also request a free sample and the table of contents in the meantime.
Yes. Bonafide Research can add countries, segments or company profiles to match your requirements. Request customisation.
One individual can access, store, display, or archive the report in Excel format but cannot print, copy, or share it. Use is confidential and internal only. License information
One individual can access, store, display, or archive the report in PDF format but cannot print, copy, or share it. Use is confidential and internal only. License information
Up to 10 employees in one region can store, display, duplicate, and archive the report for internal use. Use is confidential and printable. License information
All employees globally can access, print, copy, and cite data externally (with attribution to Bonafide Research). License information